

Inductive Sensor, For Use in Vehicle Board Nets, Operating voltage 8.6…65 VDC, Rated switching distance 8 mm, Flush, Threaded barrel, M18 x 1, Stainless steel, 1.4301, For vehicle board nets, 12 V and 24 V, Increased interference immunity 100 V/m radiated acc. ISO 11452-4 and 100 mA BCI acc. to ISO 11452-2, Load-dump protection acc. to DIN ISO 7637-2 (SAE J 113-11), Extended temperature range, High protection class IP68/IP69K, Protection against salt spray and rapid temperature change, Laser engraved label, permanently legible, DC 3-wire, 8.4…65 VDC, NO contact, PNP output, M12 x 1 male connector, E1 type approval from German federal office for motor vehicles
- SKU4047101201154
- Manufacturer code1584010
- Length of sensor52 mm
- Diameter sensor18 mm
- Flush / Non-flushConcise
- Switching distance8 mm
- Suitable for safety functionsfalse
- Type of switch functionNormally open contact
- Type of switching outputPNP
- Type of electric connectionPlug-in connection
- Type of actuationMetallic Target
- Construction type housingCylinder, screw-thread
- SIL according to IEC 61508None
- Performance level according to EN ISO 13849-1None
- Supply voltage8.6 - 65 V
- Voltage typeDC
- Switching frequency500 Hz
- Compression-resistantfalse
- Explosion safety category for gasOther
- Explosion safety category for dustOther
- Housing materialMetal
- Type of switching outputPNP
- Flush / Non-flushFlush
- Connector gendermale
- Approvals / ComplianceE1 type approval
- Manufacturer Turck